Does it fit my set?
Which wooden train brands work together?
Almost all of them, almost all of the time — and the exceptions are predictable once you know which four numbers actually decide it.
Fit comes down to four measurements
Wooden track connects with a peg on one end and a socket on the other. Whether two pieces from different brands join cleanly is decided by four dimensions, and nothing else:
- Groove width — how wide the two channels the wheels run in are, and how far apart.
- Groove depth — how deep those channels are cut. A shallow groove lets wheels climb out on a curve.
- Peg diameter — the round tab that plugs into the next piece. A fraction under and the joint is loose; a fraction over and it will not seat.
- Track thickness — total height. A mismatch here does not stop the pieces connecting, it just leaves a step the train bumps over.
A brand that copied the original geometry interchanges freely. A brand that drifted on one of the four gives you exactly one symptom, which is why the symptom tells you which number is off.
No numbers are published on this page yet. Each one has to come off calipers on a physical piece of each brand. Plausible-looking guesses would make this the most confidently wrong page on the site, so it stays empty until it is measured.
Common questions
- Do all wooden train tracks fit together?
- Mostly, but not always. Fit is decided by four measurements: groove width, groove depth, peg diameter and track thickness. Brands that copied the original BRIO geometry interchange freely; the ones that did not will either sit proud, wobble, or refuse to seat.
- Does BRIO track fit Thomas Wooden Railway?
- In general yes — both use the same nominal groove spacing, and most households mix them without trouble. Older Thomas pieces and some licensed runs vary in track thickness, which shows up as a small step at the joint rather than a failure to connect.
- What about IKEA Lillabo?
- The Lillabo train line was discontinued, so this matters mainly for people extending a set they already own. The track geometry was close enough that most pieces interchange, with fit at the peg being the usual point of difference.
- Can I connect wooden track to plastic track?
- Not directly — the connection geometry is completely different. It needs an adapter piece with a wooden peg or groove on one end and the plastic system's connector on the other.
- Why will two male ends not connect?
- Because standard track is peg on one end, socket on the other. Two peg ends meeting is the single most common reason a layout will not close, and the fix is a female-female connector — a short piece with a socket at each end.
Brand-by-brand grid
Nothing to put in it yet. A grid of 30 cells all reading "not checked" would look like an answer and be none. It appears here the moment the first pair has been measured, and grows one measured pair at a time.
In the meantime the questions above cover the combinations people actually ask about, and the four measurements will settle any pair you own in about two minutes.
When two pieces will not connect
The most common cause is not brand mismatch at all — it is two peg ends meeting. Standard track is peg on one end and socket on the other, so a loop that does not close usually needs a connector, not a different brand.
Three pieces in the range exist partly to close loops that will not close:
- Switch Track — Two blue-lever turnouts, one of each end type, so the pair closes any loop they open.
- Little Fork — A fork the size of a palm — the little one. One line in, three lines out.
- Long Wiggly Track — Wooden track that wiggles into shape. Closes the gap that nothing else will.